Perle Systems RIO 5500036-17 - Manual (Page 168)

RIO Remote I/O System User Guide
Installing Remote Terminal Adaptors (RTAs)
Page 168
Chapter 2 Installing hardware and software
RRC16 Remote Concentrator
Installation procedure
To install an RRC16 proceed as follows;
1. Mount the unit depending on the type of installation you require. For example, rack
mounted, wall mounted and so on. See Mounting the RRC16 on page 170 for details.
2. Connect the link cables from the host card or other RTA to your RRC16 into the link
socket of your choice.
Warning
When using multiple RRC16s, first fit the rubber mounting feet
supplied with each unit (see
page 170 ), and do not stack the
units more than four high as this may cause overheating.
Link ports A to D
RJ45 Ports 1 to 16
Run LED
(shows RRC16 has booted up
successfully and is running)
Power
Link status LEDs
Configuration LED
(shows RRC16 has been
configured by host)
RJ45 Port Transmit
RJ45 Port Receive LED
Details of RJ45
Port LEDs