Perle Systems RIO 5500036-17 User Manual

Page 298

RIO Remote I/O System User Guide
SCO UnixWare troubleshooting

Page 298

4. In the test parameters window, use the cursor keys to select the value you want to set

then cycle through to the value you want using the space bar key.

5. Once you have set all the test parameters you require, press the Enter key to start the

test.

The test now runs and displays the test results window shown in the next picture on
completion.

6. Once you have finished viewing the results of your test, press the

Enter

key to return to

the Online Diagnostics menu.

7. Press the

Esc

key to return to the main RIO configuration utility window (

) and

then press the

Esc

key again to exit the utility.

8. If you have finished running port diagnostics you now need to re-enable the port you have

tested.To do this, At the command prompt, type

/etc/spxadmport enable r00x

(when r00x is the port number for example, r001) and press the

Enter

key.

For more information about

spxadmport

, see

Hint

If required, you can halt the test by pressing the

Enter

key.