Perle Systems RIO 5500036-17 - Manual (Page 80)

RIO Remote I/O System User Guide
Installing RIO under SCO UnixWare
Page 80
Chapter 2 Installing hardware and software
3. In the Software Device Driver selections menu, click on the Communications Cards
option and press the Enter key.
The Software Device Drivers window is now displayed
4. In the Software Device Drivers window, select the RIO driver (hint use the arrow keys to
move the cursor) and then press the F5 key to add the new host card.
The New Hardware Configuration window is now displayed.
5. In the New Hardware Configuration window, set the parameters listed in the next table to
the values indicated.
Note
The MemStart and MemEnd values you set here must correspond to the values
set on the host card as detailed in Installing an ISA host card on page 158 .
The IRQ level should be an IRQ that is not already in use by the system.