Perle Systems RIO 5500036-17 - Manual (Page 78)

RIO Remote I/O System User Guide
Installing RIO under SCO UnixWare
Page 78
Chapter 2 Installing hardware and software
Installing device drivers and utilities
To install the RIO device drivers and utilities for the SCO UnixWare operating system
proceed as follows;
1. Login to your system as root.
2. Load the CDROM into your system CD drive.
3. Mount the CDROM by typing the following at the command prompt;
mount -r -Fcdfs -0 nmconv=c /dev/cdrom/cdrom1 /mnt
4. Press the Enter key.
5. At the command prompt, type
pkgadd -d /mnt/drivers/rio/unixware/riouw.pkg rio and then press the Enter key.
A series of progress messages is now displayed finishing with thew command prompt.
6. Reboot your system.
The RIO device drivers and utilities for the SCO UnixWare are now installed and activated.
Note
The exact syntax of this command may differ slightly on different versions of SCO
UnixWare. For details of exact syntax, please consult the documentation supplied with your
operating system.