Perle Systems RIO 5500036-17 - Manual (Page 314)

RIO Remote I/O System User Guide
Windows NT troubleshooting
Page 314
5. At the Dos prompt, type riodiags and press the Enter key.
Where are the commands needed to the different types of test available.
The general types of tests available are shown in the next table. For details of commands,
see
Test options guide on page 315 and Additional options on page 317 .
The complete suite of tests will commence.
6. Should any of the other tests indicate a failure, check your host card’s physical address or
interrupt are not clashing with other devices/memory. Do this by using the -installed
information query (see Additional options on page 317 ). Try a different interrupt and/or
memory address for the RIO card.
7. Upon completion of the tests, press the Esc key to return to the DOS prompt.
Type of test To run this type of test..
Individual tests At the dos prompt, type riodiags followed by the test
option you require. For example, riodiags -cpu :
Multiple tests At the dos prompt, type riodiags followed by the test
names on the same command line separated by spaces,
for example,
riodiags -cpu -prom -config
Running tests
on multiple
host cards At the dos prompt, type
riodiags -board , , etc.
up to the maximum of four cards. If one of the cards is an
ISA card, add the string
-isa
For example, riodiags -board 0,1,2 cpu
and
riodiags -isa 0xd0000 -board 0,1,2 -cpu
Specify the test name in either upper or lower case; the
test identifier can be either ‘-’ or ‘/’.
Note
In the event of a test failure the programme will not execute the remainder of the tests. If you
can, clear the problem on the failed test and re-run the tests.
Note
If all the tests pass, the programme will complete and return you to the DOS prompt.