Perle Systems RIO 5500036-17 - Manual (Page 51)

RIO Remote I/O System User Guide
Installing RIO under Solaris
Page 51
Chapter 2 Installing hardware and software
Updating your RIO system configuration
If you make any changes to your RIO system such as adding or removing an RTA for
example, you need to update your system using the
rioconfig utility to recognise the revised
configuration.
To do this proceed as follows;
• At the command prompt, type rioconfig and press the Enter key.
The following message is now displayed followed by the return of the command prompt.
Your RIO and Solaris system files are is now updated to include the revised configuration
taking into account any new or removed RTAs and serial ports.
Note
The rioconfig utility runs automatically when system first installed
(see Installing device drivers and utilities on page 39 ) and each
time you re-boot the system.