Regulatory information – Palm Treo 700w User Manual
Page 253
245
Regulatory Information
FCC Statement This equipment has been tested and found
to comply with the limits for a Class B computer peripheral,
pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
RF Safety Exposure To Radio Frequency Energy (SAR) Radio
transmitting devices radiate Radio Frequency (RF) energy during
its operation. RF energy can be absorbed into the human body
and potentially can cause adverse health effects if excessive
levels are absorbed. The unit of measurement for human
exposure to RF energy is “Specific Absorption Rate” (SAR).
The Federal Communications Commission (FCC), Industrie
Canada (IC), and other agencies around the world have
established limits that incorporate a substantial safety margin
designed to assure the safety of all persons using this
equipment.
In order to certify this unit for sale in the US, Canada and
Europe this unit has been tested for RF exposure compliance
at a qualified test laboratory and found to comply with the
regulations regarding exposure to RF Energy.
SAR was measured with the unit transmitting at its maximum
certified RF power. Often, however, during normal operation the
unit will transmit much less than maximum power. Transmit
power is controlled automatically and, in general is reduced
as you get closer to a cellular base station. This reduction in
transmit power will result in a lower RF energy exposure and
resulting SAR value.
FCC RF Safety Statement In order to comply with FCC RF
exposure safety guidelines, users MUST use one of the following
types of bodyworn accessories.
1. A Palm
®
brand body-worn accessory that has been tested for
SAR compliance and is intended for use with this product.
2. An accessory that contains NO metal (snaps, clips, etc) and
provides AT LEAST 1.5 cm of separation between the users
body and the unit.
Do NOT use the device in a manner such that it is in direct
contact with the body (i.e. on the lap or in a breast pocket).
Such use will likely exceed FCC RF safety exposure limits.
See or more information on RF
exposure safety.
The Palm
®
Treo™ 700w smartphone may be used with a
Wi-Fi
®
SDIO card; however, the user must ensure that the SDIO
Wi-Fi card has been approved by the FCC for use with the Treo
700w smartphone. For a list of SDIO Wi-Fi cards approved by the
FCC for use with the Treo 700w smartphone, please go to
If using a SDIO Wi-Fi card not approved for use with the Treo
700w smartphone by the FCC, the user must turn off the phone
(CDMA radio) on the Treo 700w smartphone.