Planet Technology WGSD-8000 - Manual (Page 376)

User’s Manual of WGSD-1022/WGSD-8000
- 376 –
console config-if(Config-VLAN)# dot1x auth-not-req
5.29.17 dot1x multiple-hosts
The dot1x multiple-hosts interface configuration command allows multiple hosts (clients) on an 802.1X-authorized port, that
has the dot1x port-control interface configuration command set to auto. Use the no form of this command to return to the
default setting.
dot1x multiple-hosts
no dot1x multiple-hosts
This command has no arguments or keywords.
Default Configuration
Multiple hosts are disabled. If a port would join a port-channel, the state would be multiple hosts as long as the port is member in
the port-channel.
Command Mode
Interface configuration (Ethernet) mode
User Guidelines
This command enables the attachment of multiple clients to a single 802.1X-enabled port. In this mode, only one of the attached
hosts must be successfully authorized for all hosts to be granted network access. If the port becomes unauthorized, all attached
clients are denied access to the network.
If a port would join a port-channel, the state would be multiple host as long as the port is member in the port-channel.
Examples
The following command allows multiple hosts (clients) on an 802.1X-authorized port.
console config-if(Config-VLAN)#dot1x multiple-hosts
5.29.18 dot1x single-host-violation
The dot1x single-host-violation interface configuration command configures the action to be taken, when a station whose
MAC address is not the supplicant MAC address, attempts to access the interface. Use the no form of this command to return to
default.
Syntax
dot1x single-host-violation {forward | discard | discard-shutdown} [trap seconds]
no port dot1x single-host-violation
ƒ forward — Forward frames with source addresses not the supplicant address, but do not learn the address.