Planet Technology WGSD-8000 - Manual (Page 190)

User’s Manual of WGSD-1022/WGSD-8000
- 190 –
User Guidelines
Polling time is determined by the sntp client poll timer global configuration command.
Use the sntp client enable interface configuration command to enable sntp client on specific interface.
Examples
The following example enables anycast clients.
Console (config-if)# sntp anycast client enable
5.5.11 sntp client enable (interface)
The sntp client enable interface configuration command enables the Simple Network Time Protocol (SNTP) client on an
interface. To disable the SNTP client, use the no form of this command.
Syntax
sntp client enable
no sntp client enable
This command has no arguments or keywords.
Default Configuration
Disabled
Command Mode
Interface configuration (Ethernet, Port-Channel, VLAN) mode
User Guidelines
Use the sntp client enable global configuration command to enable broadcast clients globally.
Use the sntp anycast client enable global configuration command to enable anycast clients globally.
Examples
The following example enables the SNTP client on the interface.
console (config)# sntp client enable
5.5.12 sntp unicast client enable
The sntp unicast client enable global configuration command enables the device to use the Simple Network
Time Protocol (SNTP) to request and accept Network Time Protocol (NTP) traffic from servers. To disable requesting and
accepting Network Time Protocol (NTP) traffic from servers, use the no form of this command.