Planet Technology WGSD-8000 - Manual (Page 234)

User’s Manual of WGSD-1022/WGSD-8000
- 234 –
5.10.5 arp
The arp global configuration command adds a permanent entry in the Address Resolution Protocol (ARP) cache.
To remove an entry from the ARP cache, use the no form of this command.
Syntax
arp ip_addr hw_addr {ethernet interface-number | vlan vlan-id | port-channel number | }
no arp ip_addr hw_addr {ethernet interface-number | vlan vlan-id | port-channel number | }
ƒ ip_addr — IP address or IP alias to map to the specified MAC address.
ƒ hw_addr — MAC address to map to the specified IP address or IP alias.
ƒ ethernet interface-number — Ethernet port number.
ƒ vlan vlan-id — VLAN number.
ƒ port-channel number — Port-channel number.
Default Configuration
By default, ARP is disabled.
Command Mode
Global Configuration mode
User Guidelines
The software uses ARP cache entries to translate 32-bit IP addresses into 48-bit hardware addresses. Because most hosts
support dynamic resolution, static ARP cache entries do not need to be specified.
Example
The following example adds the IP address 198.133.219.232 and MAC address 00-00-0c-40-0f-bc to the ARP table.
Console (config)# arp 198.133.219.232 0000.0c40.0fbc ethernet e8
5.10.6 arp timeout
The arp timeout global configuration command configures how long an entry remains in the ARP cache. To restore the default
value, use the no form of this command.
Syntax
arp timeout seconds
no arp timeout seconds
ƒ seconds — Time (in seconds) that an entry remains in the ARP cache. (Range: 1 - 40000000)
Default Configuration
The default timeout is 60000 seconds.