Planet Technology WGSD-8000 - Manual (Page 236)

User’s Manual of WGSD-1022/WGSD-8000
- 236 –
Syntax
show arp
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays entries in the ARP table.
Console# show arp
ARP timeout: 60000 Seconds
Interface IP address HW address status
------------ ------------------------ ------------------ --------
e1 10.7.1.102 00:10:B5:04:DB:4B Dynamic
g2 10.7.1.135 00:50:22:00:2A:A4 Static
5.11 LACP Commands
5.11.1 lacp system-priority
The lacp system-priority global configuration command configures the system priority. To reset to default, use the no form of
this command.
Syntax
lacp system-priority value
no lacp system-priority
ƒ value — Value of the priority. (Range: 1 - 65535)
Default Configuration
The default system priority value is 1.