10 back-pressure, 11 port jumbo-frame, Example – Planet Technology WGSD-8000 User Manual
Page 207: Syntax, Default configuration, Command mode, User guidelines
User’s Manual of WGSD-1022/WGSD-8000
- 207 –
Example
In the following example, automatic crossover is enabled on g2.
Console(config)# interface ethernet g2
Console(config-if)# mdix auto
5.7.10 back-pressure
The back-pressure interface configuration command enables Back Pressure on a given interface. To disable Back Pressure,
use the no form of this command.
Syntax
back-pressure
no back-pressure
Default Configuration
Back Pressure is disabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
Back Pressure will operate only if duplex mode is set to half.
Example
In the following example Back Pressure is enabled on e5.
Console(config)# interface ethernet e5
Console(config-if)# back-pressure
5.7.11 port jumbo-frame
The port jumbo-frame global configuration command enables jumbo frames for the device. To disable jumbo frames, use the
no
form of this command.
Syntax
port jumbo-frame
no port jumbo-frame