Planet Technology WGSD-8000 - Manual (Page 169)

User’s Manual of WGSD-1022/WGSD-8000
- 169 –
Example
The following example displays the local users configured with access to the system.
console (config)# show users accounts
Username Privilege
--------------- -------------
Bob 15
Robert 15
5.4 Address Table Commands
5.4.1 bridge address
The bridge address VLAN interface configuration command adds a static MAC-layer station source address to the bridge table.
To delete the MAC address, use the no form of the bridge address command (using the no form of the command without
specifying a MAC address deletes all static MAC addresses belonging to this VLAN).
Syntax
bridge address mac-address {ethernet interface | port-channel port-channel-number} [permanent | delete-onreset |
delete-on-timeout | secure]
no bridge address [mac-address]
ƒ mac-address — A valid MAC address.
ƒ Interface — A valid Ethernet port.
ƒ port-channel-number — A valid port-channel number.
ƒ permanent — The address can only deleted by the no bridge address command.
ƒ delete-on-reset — The address is deleted after reset.
ƒ delete-on-timeout — The address is deleted after "age out" time has expired.
ƒ secure — The address is deleted after the port changes mode to unlock learning (no port security command). This
parameter is only available when the port is in learning locked mode.
Default Configuration
No static addresses are defined. The default mode for an added address is permanent.
Command Mode
Interface configuration (VLAN) mode