Planet Technology WGSD-8000 - Manual (Page 196)

User’s Manual of WGSD-1022/WGSD-8000
- 196 –
Keyword Source or destination
running-config Represents the current running configuration file.
startup-config Represents the startup configuration file.
backup-config Represents the backup configuration file.
Image The image is executable code which is decompressed during system startup, into the
switching and routing software that manages the device. There are always two
images stored in the device flash known as "image-1" and "image-2". The images do
not necessarily have to contain the same versions of the software. One of these
images is always marked as active and the other image serves as a back-up. The
"active" image is either the last downloaded image or the image configured as the
"active" image. The switch boot code first tries to load and run the active image.
However, if the active image is found to be corrupt, the boot code tries to load the
back-up image. If the backup image is also corrupt the boot code prompts the user to
initiate the Xmodem
transfer of a valid image through the serial connection. The image file name is in the
format 6024_abcd.dos, where abcd represents the release number.
boot Boot file. The name of the image is in the format 6024_boot_abcd.rfb, where
abcd represents the release number.
tftp Source or destination URL for a TFTP network server. The syntax for this alias
is tftp:[[//location]/directory]/filename.
Xmodem Source for the file from a serial connection that uses the Xmodem protocol.
null Null destination for copies or files. A remote file can be copied to null to determine its
size.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
The location of a file system dictates the format of the source or destination URL.
The startup-config and the backup-config files cannot be copied to the running-config file.
The entire copying process may take several minutes and differs from protocol to protocol and from network to network.
Filenames cannot be a substring of "startup-config" or "running-config". e.g. the following filenames are not allowed: "s", "st",
"sta".