Planet Technology WGSD-8000 - Manual (Page 163)

User’s Manual of WGSD-1022/WGSD-8000
- 163 –
5.3.3 login authentication
The login authentication line configuration command specifies the login authentication method list for a remote telnet or console.
To return to the default specified by the authentication login command, use the no form of this command.
Syntax
login authentication {default | list-name}
no login authentication
ƒ default — Uses the default list created with the authentication login command.
ƒ list-name — Uses the indicated list created with the authentication login command.
Default Configuration
Uses the default set with the command authentication login.
Command Mode
Line Configuration mode
User Guidelines
Changing login authentication from default to another value may disconnect the telnet session.
Example
The following example specifies the default authentication method for a remote Telnet or console.
console (config) # line cnsole
console (config-line) # login authentication default
5.3.4 enable authentication
The enable authentication line configuration command specifies the authentication method list when accessing a higher
privilege level from a remote telnet or console. To return to the default specified by the enable authentication command, use
the no form of this command.
Syntax
enable authentication {default | list-name}
no enable authentication
ƒ default — Uses the default list created with the authentication enable command.
ƒ list-name — Uses the indicated list created with the authentication enable command.
Default Configuration
Uses the default set with the command authentication enable.