Kodak RFS 3570 - Manual (Page 92)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-2  Installation (Hardware & Software) — PC G
Installing the Scanner Hardware
Follow these instructions to connect the Scanner to a power source, to
connect the Scanner to your computer, and to set the Scanner SCSI
identification number.
Connecting the Scanner to a Power Source
Follow these steps to connect your Scanner to a power source:
1. Remove any remaining packing material from the Scanner and place
the Scanner on either side of your computer. (You should retain the
original shipping carton and packing materials.)
2. Press the O end of the power switch on the back of the Scanner to be
sure that the Scanner power is off.
3. Plug the appropriate end of the supplied power cable into the plug
outlet of the Scanner and the other end into a power source.
Serial Number 2
SCSI ID
3 3570
-
Plug Outlet
Power Switch
BACK OF FILM SCANNER