Kodak RFS 3570 - Manual (Page 25)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
 Installation (Hardware & Software) — Macintosh Computer G 3-3
Connecting the Scanner to Your Computer
Follow the instructions in this section to connect the Scanner, a non-
terminated SCSI device, to your Macintosh computer by using the sup-
plied cable and terminator.
NOTES: If you are a PowerBook user, consult the manuals supplied with your
computer to determine the cabling and termination requirements needed to
connect the Scanner — a non-terminated SCSI device — to your PowerBook. You
will probably need to supply a PowerBook HDI-30-pin to 50-pin SCSI cable to
complete this connection. Be certain that the cable you obtain is for connecting a
PowerBook computer to a SCSI device, not for connecting a PowerBook com-
puter to a desktop computer.
This manual assumes that you are familiar with the operation of your Macintosh
computer. If you are not, refer to the manuals and other instructions supplied with
that computer before continuing.
1. Turn off the power to your Macintosh computer and all peripherals
(turn off the computer first).