Kodak RFS 3570 - Manual (Page 110)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-20  Installation (Hardware & Software) — PC G
Each SCSI device connected to the same computer must have a different
SCSI ID number.
1. If SCSI devices other than the Scanner are connected to your com-
puter, determine their SCSI identification numbers so that you can
select a different number for the Scanner. (If necessary, refer to the
documentation for those devices to determine how to find their
numbers.)
2. If your PC has an internal SCSI disk drive(s), determine its SCSI identi-
fication number(s) so that you can select a different number for the
Scanner.
3. Double-check to make sure that the power to the Scanner is off (O).
(The O end of the switch should be pressed in and the green light at
the top left front corner of the Scanner should be off.)
4. Set the Scanner to an unused number by pressing the bottom button to
go to a higher number or the top button to go to a lower number. Do
not assign the number of any other attached SCSI device, do not
assign the number used by your SCSI host adapter, and never assign 8
or 9; additionally, consult your SCSI host adapter manual to see if
other SCSI IDs should not be used. Assign high ID numbers to devices
used most frequently.
NOTE: Make sure the power to the Scanner is off if you change its ID number at a
later time.