Kodak RFS 3570 - Manual (Page 27)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
 Installation (Hardware & Software) — Macintosh Computer G 3-5
If No External SCSI Devices Are Connected
Complete these steps if no SCSI devices are connected to your Macintosh
computer; otherwise proceed to “If External SCSI Devices Are Connected”
later in this chapter.
CAUTION: Whenever connecting or disconnecting SCSI cables,
be sure power is turned off on all devices in the SCSI chain,
including the computer and the Scanner (turn off the computer
first).
1. Select the cable (supplied with the Scanner) with the 25-pin SCSI
connector at one end and the 50-pin SCSI connector at the other end.
25-pin SCSI Connector 50-pin SCSI Connector
NOTE: If you are using a Macintosh PowerBook computer, you will need to
supply a PowerBook HDI-30-pin to 50-pin SCSI cable to complete this
connection. Be certain that the cable you obtain is for connecting a
PowerBook computer to a SCSI device, not for connecting a PowerBook
computer to a desktop computer.