Kodak RFS 3570 - Manual (Page 59)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
 Using the KODAK Driver for Adobe Photoshop (Macintosh) G 5-3
Displaying the KODAK Driver
Window
Follow the steps in this section each time that you want to acquire data
from the Scanner from within Adobe Photoshop.
1. With your computer, Scanner, and other SCSI devices (if present)
turned off, turn on the Scanner by pressing the (I) end of the power
switch on the back of the Scanner. The POWER indicator light, a
small green light at the top front left corner of the Scanner, turns on.
You’ll hear the system perform a self-test by moving its internal
mechanism. Then the Scanner is ready for use—no warm-up is
required.
CAUTION: Always turn on the Scanner before you turn on
your computer; it is important that you follow this procedure.
2. If other SCSI devices are present, turn them on. (SCSI devices can be
turned on in any order.)
3. Turn on your Macintosh Computer.
4. Run Adobe Photoshop.
5. Choose KODAK RFS 3570 from the A CQUIRE submenu of the Adobe
Photoshop F ILE menu. (The submenu may show other options.)
NOTE: If the Scanner choice does not appear on the submenu, follow the
directions in “Installing the KODAK Driver for Adobe Photoshop Software” in
Chapter 3 to ensure that the driver files are properly installed on you hard
disk.
If you see a message that “The Scanner was not found . . .” refer to this
message in “Appendix D — Messages from KODAK Drivers.”