Kodak RFS 3570 - Manual (Page 44)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-22  Installation (Hardware & Software) — Macintosh Computer G
8. Complete part A of this step for supported Photoshop versions before
version 2.5, and part B for versions 2.5 and later.
A. Drag the KODAK RFS 3570 and the RFS3570.BIN icons into the
folder on your hard disk that contains the Photoshop PS PREFS
file. Wait while the files are copied; if you are asked if the new
files should replace existing ones, respond affirmatively.
NOTE: If the PS PREFS file does not exist, you must run Photoshop (once)
to create it. If you do not place the KODAK RFS 3570 and RFS3570.BIN
icons into the same folder as PS PREFS, you will not be able to acquire
images from the Scanner.
B. Follow directions in the Photoshop manual regarding placement
of plug-in modules. For example, with Photoshop 2.5 and 3.0,
drag the KODAK RFS 3570 and RFS3570.BIN icons into the P
LUG
-
INS
folder created when you installed this version of Photoshop (or
into another folder you have designated with P
REFERENCES
to hold
plug-in modules). For Photoshop 2.5, be certain that the two files
are not placed within another folder inside the P
LUG - INS folder.
Wait while the files are copied; if you are asked if the new files
should replace existing ones, respond affirmatively.
9. Eject the diskette by dragging its icon to the T
RASH
icon.
10. Store the diskette. (Although copying the driver files is a onetime
action, you may need to use the diskette again.)
The driver is now installed in your Macintosh computer and the Scanner
is now ready for use as described in Chapter 4 and Chapter 5.