Sun Microsystems Sun Fire X4200 - Manual (Page 93)

Chapter 7 Command Line Interface Tasks 7-17
7.9.3.3 Examples
When changing the parameters of SNMP users, you must set values for all of the
properties, even if you are not changing all of the values. For example, to change
user al's privacyprotocol to DES you must type:
set /SP/services/snmp/users/al privacyprotocol=DES
privacypassword= password authenticationprotocol=SHA
authenticationpassword= password
Your changes would be invalid if you only typed:
set /SP/services/snmp/users/al privacyprotocol=DES
Note – You can change SNMP user permissions without resetting the privacy and
authentication properties.
7.10 How to Manage ILOM Alerts
You can display or configure alerts from the service processor command-line
interface. You can configure up 15 alerts that can be sent to an IP address. Only IPMI
PET alerts are supported. The default value for alerts is disable. To enable an alert,
set the alert's value to something other than "disable".
7.10.1 Displaying Alerts
Type this command to display alerts:
show /SP/alert/rules
7.10.2 Configuring Alerts
Use the set command to change properties and values for alerts.
7.10.2.1 Syntax
set target [propertyname=value]