Sun Microsystems Sun Fire X4200 - Manual (Page 45)

Chapter 3 SP Initial Setup 3-5
3. Unpack your server and connect the system power cable to a power source.
Refer to the Sun Fire X4100 and Sun Fire X4200 Servers Setup Guide (819-1155 for
instructions on installing the hardware, cabling, and powering on.
3.2.2 What To Do
1. Connect a serial cable from the RJ-45 SERIAL MGT port on the server’s back
panel to a terminal device. See FIGURE 3-3 .
FIGURE 3-3 Serial Management Port
Note – The serial port on the ILOM Service Processor requires that the serial cable
connected to it use the same pin assignments as the serial cable connector for the
Sun Advanced Lights Out Manager (ALOM) or Remote System Control (RSC). See
TABLE 3-3 .
2. Press Enter on the terminal device to establish a connection between that terminal
device and the ILOM SP.
TABLE 3-3 Serial Management Port Pinouts
Pin Signal Description
1 Request To Send (RTS)
2 Data Terminal Ready (DTR)
3 Transmit Data (TXD)
4 Ground
5 Ground
6 Receive Data (RXD)
7 Data Carrier Detect (DCD)
8 Clear To Send (CTS)