Sun Microsystems Sun Fire X4200 - Manual (Page 68)

5-2 Sun Fire X4100 and Sun Fire X4200 Servers System Management Guide • December 2005
5.1.2 Using the CLI
There are two privilege levels available for service processor users: Administrator
and Operator. Administrators have full access to service processor functionality and
Operators have read-only access to service processor information.
Syntax
The syntax of a command is:
Command Verbs
The service processor CLI supports the following DMTF CLP command verbs.
Object Namespace
The DMTF CLP model focuses on a hierarchical namespace, which is a predefined
tree that contains every managed object in the system. This namespace defines the
targets for each command verb. The service processor can access two namespaces:
the /SP namespace and the overall system namespace /SYS. In the /SP namespace
you manage and configure the service processor. In the /SYS namespace you access
sensors and other information for managed system hardware.
TABLE 5-1 CLI Command Verbs
Command Description
cd Navigates the object namespace.
create Sets up an object in the namespace.
delete Removes an object from the namespace.
exit Terminates a session to the CLI.
help Displays Help information about commands and targets.
load Transfers a file from an indicated source to an indicated target.
reset Resets the state of the target.
set Sets target properties to the specified value.
show Displays information about targets and properties.
start Starts the target.
stop Stops the target.
version Displays the version of service processor firmware running.