Sun Microsystems Sun Fire X4200 - Manual (Page 73)

Chapter 6 Command Line Interface Reference 6-3
TABLE 6-4 Network and Serial Port Setting Commands
Description Command
Display network
configuration information. show /SP/network
Change network properties
for the service processor.
Changing certain network
properties, like the IP
address, will disconnect
your active session. set /SP/network pendingipaddress= ipaddress pendingipdiscovery=
dchp|static pendingipgateway= ipgateway pendingipnetmask=ipnetmask
commitpending=true
Display information about
the external serial port. show /SP/serial/external
Change the external serial
port configuration. set /SP/serial/external pendingspeed= integer commitpending=true
Display information about
the serial connection to the
host. show /SP/serial/host
Change the host serial port
configuration.
Note: This speed setting
must match the speed
setting for serial port 0,
COM1 or /dev/ttyS0 on the
host operating system. set /SP/serial/host pendingspeed= integer commitpending=true
TABLE 6-5 Alert Commands
Description Command
Display information about
PET alerts. You can configure
up to 15 alerts. show /SP/alert/rules/1...15
Change alert configuration. set /SP/alert/rules/1...15 destination= ipaddress
level= down|critical|major|minor