Sun Microsystems Sun Fire X4200 - Manual (Page 49)

Chapter 3 SP Initial Setup 3-9
4. Open a session to the ILOM SP using the IP address that you obtained in the
Before You Begin procedure.
Each ILOM SP firmware application requires a different browser or shell.
■ To establish a Secure Shell (SSH) connection to the ILOM SP command-line
interface (CLI) or IPMItool, type the appropriate connection command in the SSH
application. For example, to connect to the SP with the DHCP-assigned IP address
of 129.144.82.20, type the following command:
# ssh -l root 129.144.82.20
FIGURE 3-5 Opening a Session With an SSH Command-Line Interface
Once you have entered the default password for the SP, changeme, you can enter
commands to manage user accounts or to monitor the status of devices on your
server. See the example in
FIGURE 3-6 .