Sun Microsystems Sun Fire X4200 - Manual (Page 4)

iv Sun Fire X4100 and Sun Fire X4200 Servers System Management Guide • December 2005
2.3.3 Adding Your Server to Your SNMP Environment 2–6
2.3.4 Configuring Receipt of SNMP Traps 2–6
2.4 About IPMI 2–6
2.4.1 IPMItool 2–6
2.5 IPMI Reference Information 2–8
2.5.1 Supported IPMI 2.0 Commands 2–8
2.5.2 Sensors 2–11
3. SP Initial Setup 3–1
3.1 About Initial Setup and Configuration of the Service Processor 3–1
3.1.1 Task Map 3–3
3.1.2 ILOM Default Settings 3–4
3.2 How To Configure ILOM Using a Serial Connection 3–4
3.2.1 Before You Begin 3–4
3.2.2 What To Do 3–5
3.3 How To Configure ILOM Using an Ethernet Connection 3–6
3.3.1 Before You Begin 3–7
3.3.2 What To Do 3–8
3.4 How to Update Your ILOM Firmware 3–11
3.4.1 Before You Begin 3–11
3.4.2 What to Do 3–12
3.5 How to Configure ILOM Using a Static IP Address 3–12
3.5.1 Before You Begin 3–12
3.5.2 Configuring ILOM With the CLI and a Serial Connection 3–13
3.5.3 Configuring ILOM With the CLI and an Ethernet Connection 3–
13
3.5.4 Configuring ILOM With the Web GUI and an Ethernet
Connection
3–14
4. Remote Console Application 4–1