Siemens MC55 - Manual (Page 85)

MC55 AT Command Set
3.5 ATS18
s
m
obile
MC55_ATC_V01.05 Page 85 of 469 2/10/04
Confidential / Released
3.5 ATS18 Extended call release report
Syntax
Command Description
This command enables or disables the presentation of extended call release reports for fax and data calls. The
call release report is presented in numeric format and includes the following parameters:
If enabled the message will be reported every time a fax or data call is released or fails to be established.
Parameter Description
An odd number enables the presentation of the extended call release report. An even number disables this fea-
ture.
0 (&F) ...255
Location ID as number code (see also of
AT+CEER
). Location IDs are listed in section 3.4.1 .
Each ID is related to another table that contains a list of s.
Reason for last call release as number code (see also of
AT+CEER
). numbers and the
associated descriptions are listed in several tables, sorted by different categories in Chapter
AT+CEER
. The
tables can be found proceeding from the Location IDs listed in 3.4.1 .
Read Command
ATS18?
Response(s)
OK
Write Command
ATS18=
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % ! % ! !
Reference(s)
V.25ter
+CAUSE: ,
(num)(&W)(&V)
(num)
(num)