Siemens MC55 - Manual (Page 275)

MC55 AT Command Set
10.17 ATH
s
m
obile
MC55_ATC_V01.05 Page 275 of 469 2/10/04
Confidential / Released
10.17 ATH Manual rejection of a network request for PDP context acti-
vation
Syntax
Command Description
The V.25ter
ATH
command may be used to deactivate all PDP contexts which are active or online on the same
interface.
The
ATH
command may also be used to reject a network request for PDP context activation announced by the
unsolicited result codes "RING" or "
+CRING
:GPRS".
Notes
• In contrast to GSM 07.07 it is possible to cancel a connection with
ATH
after a break. This is done for com-
patibility reasons due to the "dial-up network" drivers of Microsoft Windows.
•
ATH
is used as a standard V.25ter AT Command, too.
• If
ATH
is used to reject a network request for PDP context activation, then other PDP contexts on the same
interface which are active or online will not be deactivated.
Exec Command
ATH
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
% % § % § §
Reference(s)
GSM 07.07