Ats0, Obile, Mc55 at command set – Siemens MC55 User Manual
Page 276
MC55 AT Command Set
10.18 ATS0
s
m
obile
MC55_ATC_V01.05
Page 276 of 469
2/10/04
Confidential / Released
10.18
ATS0 Automatic response to a network request for PDP context
activation
Syntax
Command Description
(Automatic answer) command may be used to turn off (n=0) and on (n>0) the automatic
response to a network request for a PDP context activation.
When the
> 0) command is received, the MT will attempt to perform a GPRS attach if it is not
yet attached and if ME is configured to do this (see
, parameter
). Failure will result in ERROR
being returned to the TE. Subsequently, the MT will announce a network request for PDP context activation by
issuing the URC RING or CRING to the TE, followed by the intermediate result code CONNECT. The MT then
enters V.25ter online data state and follows the same procedure as it would after having received a
=1
command with no
values specified.
=0 does not perform an automatic GPRS detach.
Parameter Description
000
(&F)
automatic answering is disabled
001-255
enable automatic answering on the specified ring number
Notes
• If different settings are used on each interface, and a request for PDP context activation is received, the inter-
face 'wins' which is idle and uses the smallest
value.
Read Command
ATS0?
Response(s)
OK
Write Command
ATS0=
Response(s)
OK
PIN
ASC0
ASC1
MUX1
MUX2
MUX3
§
%
%
%
%
%
Reference(s)
GSM 07.07
(num)(&W)(&V)