Siemens MC55 - Manual (Page 139)

MC55 AT Command Set
7.2 ATA
s
m
obile
MC55_ATC_V01.05 Page 139 of 469 2/10/04
Confidential / Released
7.2 ATA Answer a call
Syntax
Command Description
TA causes remote station to go off-hook (e.g. answer call).
Parameter Description
Connection status
output only if
ATX
parameter setting with value greater 0.
Notes
• Any additional commands on the same command line are ignored.
• The command may be aborted generally by receiving a character during execution. It can't be aborted in
some connection setup states, such as handshaking.
• if
AT+FCLASS
setting is 1 or 2, all incoming calls will be answered as fax calls, if ATA is issued on multiplexer
channel 1 resp. ASC0. For calls explicitly signalled as voice or data calls, this procedure will fail with result
code "NO CARRIER", but the call in question will continue to ring.
It is possible to change the setting for
AT+FCLASS
to 0 while the call is ringing, and accept the call normally
afterwards with
ATA
.
• The ATA command may be used also to accept a network request for a PDP context activation (see
ATA
).
• See also
ATX
for .
Exec Command
ATA
Response(s)
In case of data call, if successfully connected:
CONNECT TA switches to data mode.
In case of voice call, if successfully connected:
OK
When TA returns to command mode after call release:
OK
If no connection:
NO CARRIER
PIN ASC0 ASC1 MUX1 MUX2 MUX3
% % % % % %
Reference(s)
V.25ter
(str)