Siemens MC55 - Manual (Page 260)

MC55 AT Command Set
10.9 AT+CGQREQ
s
m
obile
MC55_ATC_V01.05 Page 260 of 469 2/10/04
Confidential / Released
10.9 AT+CGQREQ Quality of Service Profile (Requested)
Syntax
Command Description
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
The read command returns the current settings for each defined context. If no requested profile was explicitly
specified for a context, simply OK will be returned, but default values will be used for that context.
This command allows the TE to specify a Quality of Service Profile that is used when the MT sends an Activate
PDP Context Request message to the network.
The set command specifies a profile for the context identified by the (local) context identification parameter,
.
A special form of the set command, +CGQREQ= causes the requested profile for context number
to become undefined.
Test Command
AT+CGQREQ=?
Response(s)
+CGQREQ:
, (list of supported s), (list of supported s), (list of
supported s), (list of supported s), (list of supported s)
OK
Read Command
AT+CGQREQ?
Response(s)
+CGQREQ:
, , , , ,
[
+CGQREQ:
, , , , , ]
...
Write Command
AT+CGQREQ=
[ [, [, [, [, [, ]]]]]]
Response(s)
OK
ERROR
+CME ERROR
PIN ASC0 ASC1 MUX1 MUX2 MUX3
% % % % % %
Reference(s)
GSM 07.07