Siemens MC55 - Manual (Page 63)

MC55 AT Command Set
3. Status Control Commands
s
m
obile
MC55_ATC_V01.05 Page 63 of 469 2/10/04
Confidential / Released
3. Status Control Commands
The AT Commands described in this chapter allow the external application to obtain various status information
from the MC55.
3.1 AT+CMER Mobile Equipment Event Reporting
This command controls details of the "
+CIEV
" URC presentation related to
AT^SIND
and
AT+CIND
. If registered
via these commands the URCs are sent whenever a value of the related indicator changes.
In addition,
AT+CMER
controls "
^SLCC
" URCs related to
AT^SLCC
. For details refer to
Call Status Infor-
mation
,
AT^SLCC
and
AT^SCFG
, parameter . After
AT+CMER
has been switched on, URCs for all reg-
istered indicators will be issued.
Syntax
Test Command
AT+CMER=?
Response(s)
+CMER:
(list of supported s), (list of supported s), (list of supported s), (list of
supported s), (list of supported s)
OK
Read Command
AT+CMER?
Response(s)
+CMER:
, , , ,
OK
Write Command
AT+CMER=
[ [, [, [, [, ]]]]]
Response(s)
OK
ERROR
+CME ERROR
PIN ASC0 ASC1 MUX1 MUX2 MUX3
% % % % % %
Reference(s)
GSM 07.07