Index, Obile, Mc55 at command set – Siemens MC55 User Manual
Page 332
MC55 AT Command Set
12.11 AT+CNMI
s
m
obile
MC55_ATC_V01.05
Page 332 of 469
2/10/04
Confidential / Released
2
Buffer unsolicited result codes in the TA when TA-TE link is reserved (e.g. in
on-line data mode) and flush them to the TE after reservation. Otherwise for-
ward them directly to the TE.
3
Forward unsolicited result codes directly to the TE. TA-TE link specific inband
technique used to embed result codes and data when TA is in on-line data
mode.
Rules for storing received SMS depend on the relevant data coding method (refer to GSM 03.38), preferred
memory storage (
) setting and this value.
Note: If AT command interface is acting as the only display device, the ME must support storage of class 0 mes-
sages and messages in the message waiting indication group (discard message)
[0]
(&F)
No SMS-DELIVER indications are routed to the TE.
1
If SMS-DELIVER is stored in ME/TA, indication of the memory location is
routed to the TE using unsolicited result code:
2
SMS-DELIVERs, except class 2 messages and messages in the message
waiting indication group (store message) are routed directly to the TE using
unsolicited result code:
3
Class 3 SMS-DELIVERs are routed directly to the TE using unsolicited result
codes defined in
=2. Messages of other data coding schemes result in
=1.
Rules for storing received CBMs depend on the relevant data coding method (refer to GSM 03.38), the setting
of Select CBM Types (
) and this value:
[0]
(&F)
No CBM indications are routed to the TE.
2
New CBMs are routed directly to the TE using unsolicited result code:
3
Class 3 CBMs are routed directly to TE using unsolicited result codes defined
in
=2.
[0]
(&F)
No SMS-STATUS-REPORTs are routed to the TE.
1
SMS-STATUS-REPORTs are routed to the TE using unsolicited result code:
2
If SMS-STATUS-REPORT is routed into ME/TA, indication of the memory
location is routed to the TE using unsolicited result code:
[1]
(&F)
TA buffer of unsolicited result codes defined within this command is cleared
when
1...3 is entered.
integer type; value in the range of location numbers supported by the associated memory
Notes
• Each time an SMS or Cell Broadcast Message is received, the Ring Line goes Logic "1" for one second.
(num)(&W)(&V)
(num)(&W)(&V)
(num)(&W)(&V)
(num)(&W)(&V)
(num)