Siemens MC55 - Manual (Page 428)

MC55 AT Command Set
17.1 AT+CALA
s
m
obile
MC55_ATC_V01.05 Page 428 of 469 2/10/04
Confidential / Released
EXAMPLE 2
To set a fresh alarm using the same message as in Example 1, simply enter date and time. , ,
, can be omitted:
When the alarm is executed the URC comes with the same message:
EXAMPLE 3
To configure the alarm mode, e.g. for May 20, 2004, at 8.30h, enter
Next, power down the ME:
When the alarm is executed the ME wakes up to Alarm mode and displays a URC. If available, this line is
followed by the individual
most recently saved. If no individual message was saved only the first line
appears.
17.1.1 Summary of AT commands available in Alarm mode
Table 17.1: List of AT Commands Available in Alarm and Charge-only Mode>
AT+CALA="04/05/31,08:50:00"
OK
+CALA: Good Morning
AT+CALA="04/05/20,08:30:00"
OK
AT^SMSO
^SMSO: MS OFF
^SYSSTART ALARM MODE
+CALA: Good Morning
AT command Use
AT+CALA
Set alarm time
AT+CCLK
Set date and time of RTC
AT^SBC
In Alarm mode, you can query the present current consumption only and check
whether or not a charger is connected. The battery capacity is returned as 0,
regardless of the actual voltage (since the values measured directly on the cell are
not delivered to the module).
AT^SCTM
Query temperature of GSM engine
AT^SMSO
Power down GSM engine