Siemens MC55 - Manual (Page 187)

MC55 AT Command Set
8.2 AT+COPS
s
m
obile
MC55_ATC_V01.05 Page 187 of 469 2/10/04
Confidential / Released
8.2 AT+COPS Operator selection
This command can be used to query the present status of the ME's network registration and to determine
whether automatic or manual network selection shall be used.
Automatic mode: Lets the ME automatically search for the home operator. If successful the ME registers to the
home network and enters the IDLE mode. If the home network is not found, ME goes on searching. If then a
permitted operator is found, ME registers to this operator. If no operator is found the ME remains unregistered.
Manual mode: Desired operator can be manually entered, using the AT+COPS write command syntax. If oper-
ator is found, ME registers to this operator immediately. If the selected operator is forbidden, the ME remains
unregistered.
Manual/automatic: In this mode, the ME first tries to find the operator that was manually entered. If the ME fails
to register to this operator, then it starts to select automatically another network.
Syntax
Test Command
AT+COPS=?
Response(s)
+COPS:
[list of supported:( , long alphanumeric , , numeric )][, , list of supported
s, list of supported s]
OK
ERROR
+CME ERROR
Read Command
AT+COPS?
Response(s)
+COPS:
[, [, ]]
OK
ERROR
+CME ERROR
Write Command
AT+COPS=
[, [, ]]
Response(s)
OK
ERROR
+CME ERROR
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % % % % %
Reference(s)
GSM 07.07