Siemens HIPATH 8000 - Manual (Page 67)

Extended Administration
67
Configuring Date and Time
If the DHCP server in your network provides information about the SNTP
server access, the date and time is automatically shown on the phone.
If the DHCP server in your network does not provide a SNTP address you
have to set the SNTP address manually.
If no SNTP server is in your network you have to configure the date and
time manually.
SNTP is available, but no automatic access by DHCP server
No SNTP server available
If SNTP is being used, any user specified value for Time and Date
will be overwritten when the next SNTP update occurs!
Parameter
Phone path
(Menu Æ page 148)
Web Interface path
(Menu Æ page 110)
SNTP Address
Æ page 219 - 04=Date/Time
- 1=SNTP IP addr
(change IP address
1 )
1 or host name (if DNS is applicable Æ page 41)
- Time and date
- SNTP server IP address or DNS
name
(enter IP address
* )
Timezone Offset
Æ page 225 - 04=Date/Time
- 2=Timezone offset
(change timezone offset) - Time and date
- Time zone offset
(enter timezone offset)
Parameter
Phone path
(Menu Æ page 148)
Web Interface path
(Menu Æ page 110)
Date/Time
Æ page 173
Y
- 2=Configuration
- 03=Date/time
(select a date format and
change date and time) - Time and date
- Local time/Date
(enter Local time, enter/select
Date)
Daylight Saving
Time
Æ page 174
Y
- 2=Configuration
- 14=Daylight Saving
(switch on/off) - Time and date
- Daylight saving
(activate/deactivate checkbox)