Ftp account name, Ftp passive mode, Ftp password – Siemens HIPATH 8000 User Manual
Page 187: Ftp account name ftp passive mode ftp password, Æ ftp account name, Æ ftp password
Alphabetical Reference
187
FTP account name
• Refer to the documentation of your FTP server for information about
the FTP account.
• Value range table:
• Editing by phone: Text Editor Æ page 155.
FTP passive mode
If the passive FTP (also "passive mode") is activated, the telephone trans-
mits a PASV command, the server opens a port and transmits this together
with the IP address to the telephone. Usually both sides use a port higher
than 1023.
This method is used if the server cannot reach the telephone. This is for
example the case if the telephone is switched by a router which translates
the telephone address using NAT, or if a firewall shields the network of the
telephone from external attacks.
FTP password
• Enter the password defined in the Æ FTP server as password for ac-
cessing this server.
• The password must correspond to the Æ FTP username and match the
password on the server.
• Value range table:
• Editing by phone: Password Editor Æ page 158.
• After factory reset the FTP password is replaced with the string
"123abc".
Permitted values
alphanumeric
Length max.
92 digits
Permitted values
alphanumeric
Length max.
24 digits
Default value
123abc