Safety precautions, Important notes – Siemens HIPATH 8000 User Manual

Page 2

Safety Precautions

Important Notes

• This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful in-

terference when the equipment is operated in a commercial environ-

ment.

• This equipment generates, uses, and can radiate radio frequency ener-

gy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harm-

ful interference, in which case the user will be required to correct the

interference at his own expense.

• The IP telephone optiPoint 410/420 S V7.0 complies with the European

standard EN 60 950.

• The earpiece in this telephone handset contains a magnet. To prevent

injury, before each use ensure objects such as pins or staples are not

stuck to the earpiece.

• There is always the danger of small objects being swallowed by young

children. In the case of the optiPoint 410/420 S V7.0, this applies in par-

ticular to the connecting cord clip.

Please make sure that such items are not accessible to children.

• Never allow the telephone to come into contact with staining or corro-

sive liquids, such as coffee, tea, juice or soft drinks.

The information provided in this document contains merely general de-

scriptions or characteristics of performance features which in case of actu-

al use do not always apply as described or which may change as a result

of further development of the products.

Do not operate the telephone in environments where there is

a danger of explosions.

Use only original Siemens accessories. Using other accesso-

ries may be dangerous, and will invalidate the warranty and

the CE mark.

Never open the telephone or a key module. If you encounter

any problems, contact System Support.

Attention

If the optiPoint 410/420 S V7.0 is supplied with power over the LAN

interface Æ page 232, the power source must be a limited power

source PowerHub compliant with IEC 60950.