beautypg.com

Starting up the optipoint 410/420 s v7.0 – Siemens HIPATH 8000 User Manual

Page 21

background image

Installation

21

Starting up the optiPoint 410/420 S V7.0

• Plug the short end of the handset cable into the handset and the other

end into the connector 2 at the bottom of the telephone and feed the

cable through the guide channel in the base unit.

• Using the headset connector:

Plug the jack of the headset cable into connector 6 at the bottom of the

telephone and feed the cable through the guide channel in the base

unit.

• Using optiPoint modules (4):

Mount this device following the instructions in the installation guide

(A31003-H8400-B934-*-6ZD1).

• Using adapter (7, 8):

Mount this device following the instructions in the installation guide

(A31003-H8400-B934-*-6ZD1).

• Using an external keyboard:

Plug the keyboard cable into the USB connector 9 at the bottom of the

telephone.

• Using a LAN connection to PC:

Plug the jack of the connection cable into the connector 5 at the bottom

of the telephone.

Only if power not supported by LAN:

– Plug the plug-in power supply unit into the mains.
– Plug the connector 3 at the bottom of the telephone into the plug-in

power supply unit.

• Plug the jack of the LAN cable into the connector 1 at the bottom of the

telephone and connect the cable with LAN.

• Feed the cables through the relief on the back of the housing and fix

them by means of the cable clip.

The optiPoint 410/420 phone is to connect to a Switch. (The phone

is working also on a Hub, but without a guarantee of quality)

The Western plugs of all cable connections must audibly snap into

place.

7

Use only the plug-in power supply unit fitting the optiPoint 410/420:

– GER/IM: AUL:06D1284
– GBR: AUL:06D1287
– USA: AUL:51A4827