IBM Tape Library Magstar 3494 - Manual (Page 278)

3. Click on the Enable password check box ( Figure 166).
4. Type the current password. (The default password is lmpsword.)
5. Type the new password. The following are the password guidelines:
v One to eight characters
v Uppercase or lowercase letters A–Z
v Digits 0–9
v Embedded blanks (blanks after the last character are ignored)
6. Type the new password again after Verify new password.
7. Click on the Change push button. A message confirming the password change
appears.
Note: Give the password to the remote library manager console operator.
Figure 165. Session Pull-down Menu
Figure 166. DCAF Password
256 Magstar 3494 Tape Library Operator Guide