IBM Tape Library Magstar 3494 - Manual (Page 276)

– Terminate the session. All remote operations stop until a new session is
established.
– Suspend the session. Control returns to the library manager.
– Monitor the session. The remote library manager console can monitor the
display on the library manager, but the keyboard on the library manager is
active.
v The library manager operator can change the session state by using the hot-key
combination at the library manager keyboard as follows:
1. Press Alt+T on the library manager console. The DCAF Target window
appears, and shows that the target is busy. See Figure 164 on page 255.
2. Click once with the pointing device in the minimize box in the upper right
corner of the target window. The library manager keyboard is now
operational.
Attention: Do not close this window. If you CLOSE this window instead of
MINIMIZING it, remote console access to the library manager will be disabled
until the library manager is rebooted.
v If you want to return control to the remote library manager console or want to
allow the remote library manager console to monitor operations, change the
session state as follows:
– The remote library manager console operator can stop and restart the
connection at the remote library manager console.
– The library manager operator can restart the session as follows:
1. Press Ctrl+Esc to display the task list.
2. Select DCAF Target with the pointing device. See Figure 162.
3. From the DCAF target window, select the session window and select
Active or Monitor. See Figure 163 on page 255.
Figure 162. Window List
254 Magstar 3494 Tape Library Operator Guide
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|