IBM Tape Library Magstar 3494 - Manual (Page 129)

Enable Dual Active Accessors
Note: This selection is only available when the dual active accessors feature is
installed.
The enable dual active accessors option allows the operator to manually enable the
dual active accessors feature. When selected, the library manager displays the Dual
Active Accessor Status Pop-up Window. See Figure 55.
Disable Dual Active Accessors
Note: This selection is only available when the dual active accessors feature is
installed.
The disable dual active accessors option allows the operator to manually disable
the dual active accessors feature. When selected, the library manager displays the
Mark Accessor Active Pop-Up Window. See Figure 56 on page 108.
Figure 54. Switching Pop-Up Window
Figure 55. Dual Active Accessor Status Pop-Up Window — Enabling
Chapter 6. Advanced Operating Procedures 107