IBM Tape Library Magstar 3494 - Manual (Page 128)

When the system status screen is displayed, the switch over is complete.
Accessors
Switch Active Accessor to Standby
Note: This selection is only available when Model HA1 is installed.
The switch active accessor to standby option allows the operator to manually switch
the active accessor to become the standby accessor. When selected, the library
manager asks the operator for confirmation before continuing with the switchover
(see Figure 53).
During the switch over, the library manager displays the standby pop-up window
(see Figure 54 on page 107).
Figure 52. Switching Pop-Up Window
Figure 53. Accessor Switch Over Confirmation Pop-Up Window
106 Magstar 3494 Tape Library Operator Guide