IBM Tape Library Magstar 3494 - Manual (Page 107)

Chapter 6. Advanced Operating Procedures
The advanced operating procedures for the 3494 are described in this chapter.
Table 6 shows the advanced operating procedures an operator can perform by
using the library manager at the rear of the library.
Table 6. Quick Reference to Advanced Operating Procedures
Task Reference
Using the library manager “Using the Library Manager” on page 88.
Making selections with the library manager “Making Library Manager Selections” on
page 92.
Making selections with a keyboard “Selections with the Keyboard” on page 92.
Making selections with the pointing device “Selections with the Pointing Device” on
page 92.
Using the Help pull-down “Using the Help Pull-Down” on page 94.
Using the Help search “Help Search” on page 95.
Using the Help action bar and function keys “Help Action Bar and Function Keys” on
page 95.
Using the Operator menu “Using the Operator Menu” on page 98.
Using the Mode pull-down “Using the Mode Pull-Down” on page 99.
Using the Auto selection “Auto” on page 100.
Using the Pause selection “Pause” on page 100.
Using the Manual selection “Manual” on page 101.
Using the Online selection “Online” on page 101.
Using the Offline selection “Offline” on page 103.
Using the Service menu selection “Service Menu” on page 104.
Switching the Active Library to Standby “Switch Active Library Manager to Standby”
on page 105.
Switching the Active Accessor to Standby “Switch Active Accessor to Standby” on
page 106.
Enabling Dual Active Accessors “Enable Dual Active Accessors” on page 107.
Disabling Dual Active Accessors “Disable Dual Active Accessors” on
page 107.
Using the Shutdown selection “Shutdown” on page 108.
Using the Status pull-down “Using the Status Pull-Down” on page 109.
Using the Operational Status selection “Operational Status” on page 111.
Using the Component availability selection “Component Availability” on page 115.
Using the VTS Status selection “Using the Status Pull-Down” on page 109.
Using the Performance Statistics selection “Performance Statistics” on page 119.
Displaying Accessor Mounts per Hour Figure 70 on page 122.
Using the VTS Active data selection “VTS Active Data” on page 123.
Using the VTS Data flow selection “VTS Data Flow” on page 125.
Using the VTS Mount hit data selection “VTS Mount Hit Data” on page 126.
© Copyright IBM Corp. 1993, 1999 85
|
||