IBM Tape Library Magstar 3494 - Manual (Page 171)

6. Select the desired Output Device radio button and enter the Filename if A:
is selected.
7. Insert a non-write protected diskette in the A: drive if A: was selected.
8. Select the Create list button. An Operation In Progress message is displayed
during the list operation.
9. A completion message is displayed when the operation is complete.
v Find all volumes starting with BCD in rack 4 and display their locations and
category.
1. Select Volser for Output Column 1.
2. Select Category for Output Column 2.
3. Select Home for Output Column 3.
4. Check the Specific Rack checkbox.
5. Select rack 4 in the associated drop-down list.
6. Check the Volser Mask checkbox.
7. Enter BCD* in the Volser Mask entry field.
8. Select the desired Output Device radio button and enter the Filename if A:
is selected.
9. Insert a non-write protected diskette in the A: drive if A: was selected.
10. Select the Create list button. An Operation In Progress message is
displayed during the list operation.
11. A completion message is displayed when the operation is complete.
The panel’s pushbuttons are:
Create list
Initiate the list database volumes operation
Cancel
Close the panel.
Help Display this help panel
Chapter 6. Advanced Operating Procedures 149