Show interface command, Show port command, Show interface command show port command – Motorola CAJUN P120 User Manual
Page 90
Chapter 7
Cajun Campus CLI (Command Line Interface)
76
Cajun P120 User’s Guide
Show Interface Command
Use the
show interface
command to display information on network interfaces.
The syntax for this command is:
show interface
Example:
To display the sl0, sb1 and sb2:
Console> show interface
ib1: vlan 1 172.16.25.130 netmask 255.255.0.0
sl0: slip 0.0.0.0 dest 0.0.0.0
Console>
Show interface Command Output Fields:
Show Port Command
Use the
show port
command to display port status.
The syntax for this command is:
show port
[slot_num[/port_num]]
sl0
Information on the SLIP interface
slip
IP address of the SLIP interface
slip dest
IP address of the host to which the console port will be
connected
ib1
Information on the Agent interface
vlan
Number of the VLAN to which the ib1 interface has been
assigned (known as the management VLAN)
inet
IP address of the interface
netmask
Network mask for the interface
slot_num
Module number (always 1).
port_num
(Optional) Number of the port. If you do not specify a number,
all the Cajun P120 ports are shown.