beautypg.com

Set port negotiation command – Motorola CAJUN P120 User Manual

Page 105

background image

Chapter 7

Cajun Campus CLI (Command Line Interface)

Cajun P120 User’s Guide

91

The syntax for this command is:

set port level [slot_num/port_num][normal|high]

Example

To set the priority level for port 2 on module 1 to high:

Console>(enable) set port level 1/2 high

Port 1/2 port level set to high.

Console>(enable)

Set Port Negotiation Command

Use the

set port negotiation

command to enable or disable the link

negotiation protocol on the specified port. This command applies to ports on the
10/100 ports. When negotiation is enabled, the speed and duplex of the Fast
Ethernet ports are determined by auto-negotiation. For Gigabit Ethernet ports,
autonegotiation controls Flow Control mode (symmetric/disabled). If negotiation is
disabled, the user can set the speed and duplex of the Fast Ethernet ports.

The syntax for this command is:

set port negotiation [slot_num/port_num][enable | disable]

Example:

To disable link negotiation protocol on port 1, module 1:

Console>(enable) set port negotiation 1/1 disable

Console>(enable)

slot_num

Module number (always 1)

port_num

Number of the port on the module

normal

Set the port priority to regular

high

Set the port priority to high

slot_num

Module number (always 1)

port_num

Number of the port on the module

enable

Enable the autonegotiation protocol

disable

Disable the autonegotiation protocol