Set snmp trap command, Set system location command, Set system name command – Motorola CAJUN P120 User Manual
Page 103: Set system contact command
Chapter 7
Cajun Campus CLI (Command Line Interface)
Cajun P120 User’s Guide
89
Set SNMP Trap Command
Use the
set snmp trap
command to enable or disable the different SNMP traps
on the system or to add an entry into the SNMP authentication trap receiver table.
The syntax for this command is:
set snmp trap rcvr_addr
Examples:
To enable SNMP traps to be sent to a specific manager:
Console>(enable) set snmp trap 192.122.173.42
SNMP trap receiver added.
Console>(enable)
Set System Location Command
Use the
set system location
command to set the mib2 system location MIB
variable.
The syntax for this command is:
set system location
[string]
Set System Name Command
Use the
set system name
command to set the mib2 system name MIB variable.
The syntax for this command is:
set system name [string]
Set System Contact Command
Use the
set system contact
command to set the mib2 system contact MIB
variable
The syntax for this command is:
set system contact [string]
rcvr_addr
IP address or IP alias of the system to receive SNMP traps
string
Location string.
string
Name string.
string
Contact string