P120 port configuration group (p120), Table 6.11, P120 group parameters – Motorola CAJUN P120 User Manual
Page 73
Chapter 6
Legacy CLI (Command Line Interface)
Cajun P120 User’s Guide
59
P120 Port Configuration Group (P120)
This group includes parameters for the configuration of switched ports. The table
below shows the parameter names, default values, range of values, and value to be
used with the index keyword.
The syntax for this command is:
set|show P120
Table 6.11
P120 Group Parameters
Parameter
Description
Default
Value(s)
Valid Range for Values
ADMIN
Enables the port
to forward frames
ena
dis, ena
DUPLEX
Duplex type and
speed depending
on the device to
be connected
auto (if sup-
ported), full
(for 1000M
ports)
100-half, 100-full,
10-half, 10-full, auto
REDUNDANT
Creates up to 4
redundant pairs
none
1 primary, 1 backup
2 primary, 2 backup
3 primary, 3 backup
4 primary, 4 backup
LAG
Sets link
aggregation
none
base, link, none
FLOW-CONTROL
Enables flow
control
dis
ena, auto, dis
HOLB-P
Allows early
packet drop
dis
ena, dis
PORT-PRI
Sets port priority
regular
regular, high
PORT-VLAN
Sets port VLAN
1
1-255
VLAN-MODE
Sets VLAN
tagging
No tagging (no
802.1q tagging)
tagging, no tagging